Remove the Bluetooth module:
1. Disconnect the Bluetooth module cable (1) from the SIM/WWAN board.
2. Release the Bluetooth module cable from the routing clips (2) built into the base enclosure.
3.
Release the Bluetooth module (3) from the retention clip built into the base enclosure.
4. Remove the Bluetooth module and cable.
Reverse this procedure to install the Bluetooth module and cable.
SIM/WWAN board
Description Spare part number
SIM/WWAN board (includes cable) 608382-001
Before removing the SIM/WWAN board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery cover and battery (see
Battery on page 37), and then remove the following
components:
a.
SIM (see
SIM on page 39)
b. Hard drive (see
Mass storage device on page 40)
ENWW
Component replacement procedures
61
To Next Page
Loading...
