g. Release the ZIF connector (1) to which the touch control board cable cable is connected, and then
disconnect the touch control board cable (2) from the webcam/microphone module.
The webcam/microphone module is available using spare part number L94505-001.
The touch control board cable is available using spare part number L94500-001.
13. If it is necessary to replace the touch control board, follow these steps:
a. Remove the display panel assembly.
b. Disconnect the webcam/microphone module cables (1) and (2) from the touch control board.
c. Release the ZIF connectors (3) to which the touch control board cables are connected, and then
disconnect the touch control board cables from the touch control board.
Component replacement procedures 47
To Next Page
Loading...
