HP4402.book : chapter1.fm 5 Tue Apr 22 15:20:23 1997
Getting Started
The Front Panel at a Glance
HP EPM-441A User’s Guide 1-5
3.
This hardkey switches the power meter between on and standby.
When the power meter is switched to standby (that is, when this
hardkey has not been selected but the line power is connected to
the instrument) the red LED is lit. When the power meter is
switched on the green LED is lit.
4. “System/Inputs” hardkey with softkey menu.
The hardkey allows access to softkey menus which affect
the general power meter system setup, (for example the HP-IB
address) and also to softkey menus which effect the setup of the
channel inputs. Refer to Chapter 3 for further information about
this hardkey and it’s softkey menu.
5.
This hardkey is the only one that is completely dedicated to the
control of the power meter as a system. The only other hardkey
which affects system parameters is the hardkey. Refer to
Chapter 3 for further information about this hardkey and it’s
softkey menu.
6. Dedicated “Window” hardkeys with softkey menus.
,,
These hardkeys allow access to softkey menus which affect the
setup of the measurement windows. Refer to Chapter 3 for further
information about these hardkeys and their softkey menus.
7. Dedicated “Channel” hardkeys with softkey menus.
,
These hardkeys allow access to softkey menus which affect the
measurement channel. Refer to Chapter 3 for further information
about these hardkeys and their softkey menus.
8. Channel Input.
The HP EPM-441A has one sensor input. Power meters configured
with options 002 or 003 have the sensor inputs on the rear panel
and the front panel.
System
Inputs
Save
Recall
System
Inputs
Meas
Setup
Rel
Offset
dBm/W
Frequency
Cal Fac
Zero
Cal
To Next Page
Loading...
Need help?
General
