Hardware Reference Guide 2–27
Hardware Upgrades
3. With the top of the drive facing up and the drive connector facing
the computer, slide the drive into the MultiBay and push firmly to
ensure that the electrical connector is properly seated.
Inserting a Drive into the MultiBay
If the device does not start, ensure that the necessary device drivers
are installed on the system. If they are not available, they may be
downloaded, at no cost, from the Compaq Web site at
www.compaq.com.
Removing a Drive from the MultiBay
1. Exit all software applications, shut down the operating system
software, and turn off the computer if you are inserting or
removing a hard drive.
2. Remove the MultiBay security screw, if it has been installed.
Refer to the“Uninstalling the MultiBay Security Screw” section
for instructions on removing the MultiBay security screw.
243849-003.book Page 27 Thursday, March 14, 2002 5:07 PM
To Next Page
Loading...
