2–20 Hardware Reference Guide
Hardware Upgrades
✎
When replacing the hard drive, transfer the four screws from the old
drive to the new one. The screws take the place of drive rails.
✎
If you have installed a hard drive that is not automatically recognized
by the computer, see Appendix B, “Hard Drive Installation
Guidelines.”
Ä
CAUTION: To prevent loss of work and damage to the computer or drive:
■ If you are inserting or removing a hard drive, turn off the computer.
Do not remove a hard drive while the computer is on or in standby
mode.
■ Before handling a drive, ensure that you are discharged of static
electricity. While handling a drive, avoid touching the connector. For
more information about preventing electrostatic damage, see
Appendix E, “Electrostatic Discharge.”
■ Handle a drive carefully; do not drop it.
■ Do not use excessive force when inserting a drive.
■ Avoid exposing a hard drive to liquids, temperature extremes, or
products that have magnetic fields such as monitors or speakers.
■ If a drive must be mailed, place the drive in a bubble-pack mailer or
other suitable protective packaging and label the package “Fragile:
Handle With Care.”
Removing an Optical Drive
Ä
CAUTION: All removable media should be taken out of the drives before
removing the drive from the computer.
✎
An optical drive is a CD-ROM, CD-RW, or DVD-ROM drive.
1. If you have locked the Smart Cover Lock, use Computer Setup to
unlock the lock.
2. Turn off the computer and any external devices.
3. Disconnect the power cord from the power outlet.
4. Remove the computer cover.
5. Rotate the drive cage to the upright position.
243849-003.book Page 20 Thursday, March 14, 2002 5:07 PM
To Next Page
Loading...
