To remove the secure USB compartment cover:
1. Toward the rear of the thin client's compartment cover, remove the screw that secures the
compartment cover to the unit (1).
2. Push the compartment cover about .6 cm (1/4 inch) toward the front of the unit (2) and lift it off
the unit (3).
Figure 2-5 Removing the secure USB compartment cover
Replacing the Secure USB Compartment Cover
To replace the secure compartment cover:
1. Place the cover on top of the unit so it is offset about 0.6 cm (1/4 inch) toward the front of the
unit, allowing the tabs on the cover to align with the slots on the chassis (1).
2. Slide the cover toward the back of the unit until the cover is flush with the chassis (2).
3. Replace the screw (3).
Figure 2-6 Replacing the secure compartment cover
Removing and Replacing the Secure USB Compartment Cover 11
To Next Page
Loading...
