Setup Utility—Power Management Setup
Table 3-6 Setup Utility—Power Management Setup
Option Description
PWRON After PWR-
Fail
When power is lost and comes back, the option determines what power state the system should
go to. Options are Off, On, and Former-Sts. Default is Former-Sts.
Wake on PME Enable/disable system wakeup capability for OnBoard LAN device and PCI card. Default is
enabled.
BIOS Wake up Enable RTC alarm wakeup. Default is disabled.
Day of Week Select the alarm RTC wakeup day of Sunday through Saturday.
Time of Day Select the alarm RTC wakeup time of day (hh:mm).
Eup Lot6 Enable or disable EuP (Energy Using Product) Lot6 power consumption mode. Default is
disabled.
Setup Utility—Utility Task Actions
Table 3-7 Setup (F10) Utility Task Actions
Heading Table
Load Factory Defaults Select Yes or No (Y/N)
Set Administrator Password Allows you to set, change, and disable the administrator password.
Set User Password Allows you to set, change, and disable the user password.
NOTE: When the user password is set, it prevents unauthorized access to the user's
setup. User password provides read-only access to Setup options.
Save & Exit Setup Saves data to CMOS, then exit the Setup Utility.
Exit without Saving Exit the Setup Utility without saving any changes.
Using the BIOS Settings 23
To Next Page
Loading...
Need help?
General