HP HP-16C - Function Summary and Index; Core Operations Summary

Function Summary and Index
This section presents a summary of the various calculator
functions with page references. The functions are presented in the
following groups:
......................................... Page 120
Clearing ............c.iiiiiiiiin. Page 120
DigitEntry ........ ... ... ... L. Page 120
Stack Rearrangement ....................... Page 121
Number and Display Control ................ Page 121
Mathematics ................................ Page 121
Bit Manipulation ............................ Page 122
Memory and Storage ........................ Page 123
Index Register Control ...................... Page 123
Programming ............. ... ... ... ....... Page 123
Conditionals ................................ Page 124
[ON|Turns the [CLx|Clear X. Clears sequence (page 17).
calculator’s display
on and off (page 16).
Also used with [~ |to
reset Continuous
Memory (page 20),
with [/to change the
digit separator (page
61), and with other
keys to test the cal-
culator’s operation
(page 106).
Clearing
[BSPBackspace. In
Run mode: clears
last digit; clears
whole display if digit
entry was terminated
(page 17).In
Program mode:
deletes the current
instruction (page
83).
contents of X-register
to zero (page 17).
CLEAR [PRGM]|Clear
program memory. In
Run mode: reposi-
tions program
memory to line 000
without deleting
lines. In Program
mode: deletes all
program memory
(page 73).
CLEAR[REG]Clear
registers. Clears all
data storage
registers (page 68).
CLEAR
Cancel prefix entry.
Cancels any prefix
keystroke from a
partially entered key
Also temporarily
displays the full 10-
digit mantissa of the
number in the X-
register (Floating-
Point Decimal mode
only) (page 58).
Digit Entry
(0]through [9],
through [F|digit keys.
Can be usedonly in
the proper number
base mode (page
28).
(-|Decimal point.
Used in Floating-
Point Decimal mode
only (page 58).
[ENTER|Copies the
number in the X-
register into the Y-
120