HP HP-16C User Manual

Section 8: Program Editing 85
Keystrokes Display
002- 23 Line 002: Hexadecimal
6 h modeset.
003- 8 Line003:8.
8 h
004- 4244 Line 004: f][WSIZE].
6 h Word sizeis now 8.
005- 4336 Line005:(9g](LSTx].
8 h Brings back word size.
SST 006- 42 b Line006:(f](SR].
4 h Calculates one-half of
word size.
007- 42 E Line007:(f][RLn].
60 h Number shifted left four
bits.
008- 4240 Line 008:[f)[OR].
67 h Eight-bit concatenated
word.
SST 009- 43 21 Final instruction
67 h (return).
Further Information
Line Position
The calculator’s position in program memory does not change
when it is shut off or when Program/Run modes are changed.
Therefore, if the calculator shuts itself off, you need only turn it on
and switch to Program mode (the calculator always “wakes up” in
Run mode) to be back where you were.
The calculator cannot move to a program line that does not contain
an instruction (is not yet “created”). When you use [SST], the
calculator will “wrap around” to line 000 after encountering the
end of current program memory.
Initializing Calculator Status
The contents of storage registers and the status of calculator
settings will affect a program if the program uses those registers or
depends on a certain status setting. If the current status is

HP HP-16C Specifications

General

Brand	HP
Model	HP-16C
Category	Desktop
Language	English