HP HP-16C - Page 15

The HP-16C: A Quick Look 13/14
Keystrokes Display
(9] Returns calculator to
Run mode; no PRGM
annunciator. Display
will show the result of
the last calculation
performed.
Running the Program. Key the starting number (for example,
zero) into the display. You do not need to use since starting
the program will separate the two numbers to be added. The
program above adds 1 to whatever number you key in.
Keystrokes Display
DEC Converts to Integer
mode, base 10. (You can
start in any number
base; the program will
display the numbers in
binary.)
16 [f)(WSIZE Sets word size to 16.
0 0 d Initial number: 0.
(GSBJA 1 b Addresses and starts a
10 b program with label “A”.
11 b The momentary displays
100 b arebinary.
R/S 22 d Sincethisis an endless
loop, stop program
execution with
(run/stop). The display
shows the decimal
equivalent of the binary
value at the particular
moment you press [R/S].
This introduction to the HP-16C should give you a feel for its
operation. It is only a glimpse, however; for a look at the dozens of
other powerful HP-16C functions, turn the page and explore Part I,
HP-16C Fundamentals.