HP HP-28S - Page 23

Start with a clean sheet of paper.
.1 CLEAR I
Ii
The display shows the stack, which is your work area. Currently the
stack is empty.
Press
ITJ [[) to write 15 in the command line.
15
Note that the stack moves up to make room for the command line, so
only
three stack levels are displayed.
Put 15 on the stack.
I ENTER I
Iii
The number goes in stack level 1, as indicated by 1 : at the left. Note
that the command line disappears, so four stack levels are displayed
again.
Press
[I) rn to write 23 in the command line.
23
Put 23 in level 1.
I ENTER I
Iii
The number 15, which was in level 1, is lifted to level 2.
22 1: Getting Started
I