Removal and replacement procedures 30
7. Remove the system air baffle ("System air baffle" on page 28).
8. Disconnect the front panel LED/buttons module cable from the system board.
To remove the component:
1. Remove the front panel LED/buttons module.
To replace the component, reverse the removal procedure.
Fan modules and fan blank
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 25).
To Next Page
Loading...
