Removal and replacement procedures 34
13.
Remove the non-hot-plug drive.
To replace the component, reverse the removal procedure.
Integrated power supply
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 25).
4. Place the server on its side.
5. Remove the access panel ("Access panel" on page 26).
6. If installed, remove the PCI air baffle ("PCI air baffle" on page 27).
7. Remove the system air baffle ("System air baffle" on page 28).
8. Remove any installed full-length PCI cards ("Full-length expansion board" on page 40).
9. Remove the fan modules and the fan blank ("Fan modules and fan blank" on page 30).
10. Disconnect the power cables from the system board, drive cages, and optical drive.
To Next Page
Loading...
