Removal and replacement procedures 36
3.
Remove the power supply module.
To replace the component, reverse the removal procedure.
Optical drive
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the front bezel (on page 26).
4. Place the server on its side.
5. Remove the access panel ("Access panel" on page 26).
6. If installed, remove the PCI air baffle ("PCI air baffle" on page 27).
7. Remove the system air baffle ("System air baffle" on page 28).
8. Remove any installed full-length PCI cards ("Full-length expansion board" on page 40).
9. If installed, remove the RPS rear blank.
10. Remove fan 1 ("Fan modules and fan blank" on page 30).
11. Disconnect and remove the optical drive power and data cables.
To Next Page
Loading...
