HP HPE SimpliVity 380 Gen10 User Manual

Before you begin
You have completed these tasks:
• Obtained a replacement power supply of the same type and wattage.
• Removed the failed power supply from the server.
• Read the guidelines for maintaining power supplies.
• Read the guidelines for protecting components from electrostatic discharge.
Procedure
1. Carefully remove the replacement power supply from its packaging.
2. Slide the power supply into the empty bay until the red latch engages.
3. Ensure that the power supply is fully inserted and locked in place by the red, spring-loaded clip.
4. Connect and secure the power cable to the new power supply and to the power source.
5. Ensure that the power cables are fully inserted at both ends.
6. Power up the server.
7. Examine the LEDs and event messages to ensure the power supply is operational.
Power supply maintenance 33
Documentation Feedback: doc-feedback-hpe-storage@hpe.com

HP HPE SimpliVity 380 Gen10 Specifications

General

Processor	Intel Xeon Scalable processors
Hypervisor Support	VMware vSphere, Microsoft Hyper-V
Network	10GbE
Form Factor	2U
Power Supply	Redundant Power Supplies
Operating System	Windows Server
Management	HPE OneView
Memory	Up to 6 TB DDR4 ECC Registered DIMMs