• Connect the 1 GbE network interfaces to different 1 GbE switches.
Switch-connected network configuration
The switch-connected network configuration for a federation with two HPE SimpliVity 380 servers uses redundant connections
to 10 GbE switches for the HPE OmniStack Storage and Federation networks. It uses redundant 1 GbE connections to 1 GbE
switches for the Management network.
The following figure shows a sample configuration with rear boot drives. On your model, additional PCIe cards may be installed
in the secondary riser.
Note: Your system must have a 10 GbE connection and either an optional 1 GbE NIC in a PCIe slot or the embedded
4- port 1 GbE LOM depicted in the diagram below. Although the location of the 1 GbE interface on your system may
differ from the diagram, the port-to-port wiring is identical.
Network cabling options 36
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
