2 Million Imp - Preventive Maintenance Guide - HP Indigo press 5000
CA294-00570 rev 01 page 5 of 18
Monthly maintenance (continued)
Lubrication
Make sure that all lubrication points have been oiled
and greased properly. See "Appendix C - Grease and
oil types" on page 17.
BID engage
Verify that the BID fans are working properly.
Ventilation system
Make sure that all the Amateks are working
properly:
Scorotron (suction and blower).
ITM input fan.
Air knife (suction and blower).
Bottom cooling.
Print quality
Perform the following:
Print Fine_Tune job, adjust if necessary.
Print a gray_20 job, and verify the quality of the print.
Check writing head deskew, and adjust, if necessary.
Use the gray_20 job to observe banding of ~3.5 mm
along the format that appears due to an incorrect
deskew adjustment.
Print the CATP job. Check the press performance
according to the table of specifications attached to the
job.
Send 2 copies of each job marked with the press
serial number and the date to your service center.
To Next Page
Loading...
