How to fix build ink density calibration failure on HP Power Tool?
To address a build ink density calibration failure on your HP Power Tool: 1. Verify the Tank Ink Controller (TIC) is clean, especially the lenses area. 2. If needed, replace the TIC. 3. Dilute 200 ml (not more!) and add 200 ml of imaging oil. 4. Calibrate density. 5. Repeat the dilution until the density calibration passes.
What to do for build ink conductivity calibration failure on HP Power Tool?
To address a build ink conductivity calibration failure on your HP Power Tool: 1. Set 1.7 in the Manual Density Calibration wizard. 2. Measure conductivity with an external measuring device, troubleshoot accordingly (target 50 ±10). 3. Perform manual conductivity calibration.
What to do if BID memories observed on HP Power Tool?
If you observe image memory issues such as 'Casper,' a frame below the image, or general image memory problems with your HP Power Tool, first confirm the issue is only occurring on Silver prints. Then, use PrintCare to increase the Electrode Voltage (ELV) in steps of 50v. Alternatively, you can perform a Full Color Calibration (FCC) using the recommended Optical Density (OD) targets for your substrate.
How to improve solid quality on HP Power Tool?
If the solid quality is poor when using the HP Power Tool, first verify that the problem is only occurring on Silver prints. If so, use the Silver Color Adjustment wizard to increase the Electrode Voltage (ELV) in steps of 50v. Alternatively, perform a full color calibration (FCC) with recommended OD targets per substrate.
What to do if TE band appears on HP Power Tool?
If you notice a TE band, which is silver accumulation at the trailing edge area on your HP Power Tool prints, calibrate the BID engage if it's not symmetrical between the front and rear. Also, in overlap prevention settings, increase the leading edge by 10 mm or more. Consider using leading edge color variation correction found in Print Care Center > Maintenance > Component Calibrations.
How to fix high background on HP Power Tool?
If the background is too high when using the HP Power Tool, use the Silver Color Adjustment wizard. First, verify that the electrode voltage (ELV) is at the lowest setting (400 v). Then, optimize the cleaner voltage (CLV) for memory defects improvement by using PrintCare to print CLV values of 220, 240, 260, 280, and 300.
General| Print speed | Not applicable |
|---|---|
| Image resolution | Not applicable |
| Line screens | Not applicable |
| Maximum sheet size | Not applicable |
| Minimum sheet size | Not applicable |
| Image size | Not applicable |
| Paper weight | Not applicable |
| Paper thickness | Not applicable |
| Feeder | Not applicable |
| Stacker | Not applicable |
| Print Engine Dimensions | Not applicable |
| Print Engine Weight | Not applicable |
To Next Page
