Need help?Do you have a question about the HP 209A and is the answer not in the manual?
General| Brand | HP |
|---|---|
| Model | 209A |
| Category | Power Tool |
| Language | English |
Lists the detailed technical specifications for the Model 209A.
Specifies voltage, frequency, and power consumption for the instrument.
Explains grounding procedures for operator safety and instrument protection.
Step-by-step guide to safely power on the Model 209A instrument.
Discusses special considerations for using the Model 209A.
Explains how to synchronize the oscillator with an external signal.
Explains the function of the peak comparator and automatic gain control.
Lists the necessary test equipment for maintaining and servicing the Model 209A.
Details how to check and verify the accuracy of the frequency dial.
Procedure for measuring the harmonic distortion of the sine wave output.
Verifies the sine wave output voltage and impedance into a 600 ohm load.
Procedures for adjusting and calibrating the instrument to meet specifications.
Procedures for diagnosing and resolving instrument issues.
Checks and adjustments for the instrument's power supply voltages.
Adjusting AGC and frequency calibration for optimal performance.
Adjusts controls to minimize distortion in the output signal.
Monitors output signals using an oscilloscope for front panel symptom diagnosis.
Provides guidance for troubleshooting based on schematic diagrams and DC voltages.
Shows the detailed circuit schematics for each assembly.
To Next Page
