EasyManuals Logo

HP J9827A User Manual

HP J9827A
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
6. Run the command no module <slot> to switch configuration, if you are exchanging
one type of module with a different type of module in the same slot.
7. Issue the reload module x command, where x is the letter of the slot (A through L).
The following warning will be displayed:
WARNING! The reload module command will shut down the specified modules and
ports on those modules will not send or receive packets while the module is down. Any
management traffic for the switch passing through the affected modules will be interrupted,
including SSH, TELNET, and SNMP. It may take up to 2 minutes to completely reload the
modules. During that time, you can monitor progress by viewing the event log.
Continue (y/n)?
8. Enter ‘y’ to proceed with the swap. It will take a few seconds for the module to become
operational.
21

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP J9827A and is the answer not in the manual?

HP J9827A Specifications

General IconGeneral
BrandHP
ModelJ9827A
CategorySwitch
LanguageEnglish

Related product manuals