To Next Page

To Previous Page

4-18

Switching Features

Loop Protection

Table 4-9. Loop Protection Configuration Global Fields

If you modify these settings, click Apply to update the switch configuration. Your changes take effect

immediately.

Configuring Loop Protection Settings on Interfaces

To configure loop protection settings on one or more interfaces, select the interfaces and click Edit. Or, select

Edit All to configure all interfaces.

Figure 4-12. Edit Loop Protection Port Configuration Page

Field Description

Loop Protection Select Enabled or Disabled to administratively enable or disable this feature globally on the

switch. This feature is disabled by default.

Transmission Time The interval at which the switch sends loop protection PDUs on interfaces that are enabled to

send them. The range is 1 to 10 seconds and the default is 5 seconds.

Shutdown Time The period that a port is shut down when a loop is detected. This setting applies only to ports

that are configured to be shut down upon the detection of a loop. The range is 0 to 604800 seconds

and the default is 180 seconds.

Other manuals for HP J9979A

Questions and Answers:

Need help?

Do you have a question about the HP J9979A and is the answer not in the manual?

General