NOTE: For best results use a sheet of transparency. If you do not have any transparencies, you can use
copier-grade media, 70 to 90 g/m
2
(18 to 24 lb), with a smooth surface.
1. Make sure that the printer is idle and the Ready light is on.
2. Load the media in the input tray.
3. Print a cleaning page. Access the printer properties (or printing preferences in Windows 2000 and XP).
See
Printer properties (driver) on page 8 for instructions.
NOTE: The cleaning process takes approximately 3 minutes. The cleaning page will stop periodically during
the cleaning process. Do not turn the printer off until the cleaning process has finished. You might need to
repeat the cleaning process several times to thoroughly clean the printer.
42 Chapter 3 Maintenance ENWW
To Next Page
Loading...