Memory modules
Table 5-3 Memory modules descriptions and part numbers
Description Spare part number
Memory module, DDR4-2400, 4 GB L10598-852
IMPORTANT: Before adding new memory, be sure to update the computer to the latest BIOS from
www.hp.com. Failure to update the computer to the latest BIOS before installing new memory may result in
various system problems.
Before removing the memory module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Place the computer in Battery Safe mode (Battery Safe mode on page 29).
3. Remove the bottom cover (Bottom cover on page 30).
4. Remove the battery (Battery on page 31).
Remove the memory module:
1. Lift the protective tape from on top of the memory modules (1).
2. Spread the retaining tabs (2) on each side of the memory module slot to release the memory module.
(The edge of the module opposite the slot rises away from the computer.)
3. Remove the memory module (3) by pulling the module away from the slot at an angle.
NOTE: Memory modules are designed with a notch to prevent incorrect insertion into the memory
module slot.
Reverse this procedure to install a memory module.
32 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
