HP OMEN 32q User Manual

18
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
Function test
After repair, be sure to confirm that all functions are working.
Support and troubleshooting
The following table lists possible problems, the possible cause or each problem, and the recommended solutions.
Function test
After repair, be sure to confirm that all functions are working.
Table 4-1: Function test
Te
st item
Operating description
Tool used
HDMI test
Confirm whether image displays and sound plays
correctly on the monitor.
Computer or DVD player
DP test
Confirm whether image displays and sound plays
correctly on the monitor.
Computer or DVD player
Audio test
Change volume and balance to confirm whether
volume is smooth and loud enough.
Speaker
Table 4-1: Function test
Test item
Operating description
Tool used
HDMI test
Confirm whether image displays and sound plays
correctly on the monitor.
Computer or DVD
player
DP test
Confirm whether image displays and sound plays
correctly on the monitor.
Computer or DVD
player
Audio test
Change volume and balance to confirm whether
volume is smooth and loud enough.
Speaker
Problem
Possible cause
Solution
Screen is blank or
video is flashing.
Power cord is disconnected.
Connect the power cord.
Monitor is off.
Press the monitor power
button.
NOTE: If pressing the Power
button has no effect, press
and hold the power button for
10 seconds to disable the
Power button lockout feature.
Video cable is improperly connected.
Connect the video cable
properly.
System is in Auto-Sleep Mode.
Press any key on the
keyboard or move the mouse
to inactivate the screen
blanking utility.
Video card is incompatible.
Open the OSD menu and
select the Input menu. Set
Auto- Switch Input to Off
and manually select the
input. Or replace the video
card or connect the video
cable to one of the
computer’s on-board video
sources.
Image appears blurred,
indistinct, or too dark.
Brightness setting is too low.
Open the OSD menu and
select Brightness to adjust the
brightness scale as needed.
“Check Video Cable”
Monitor video cable is disconnected.
Connect the appropriate

HP OMEN 32q Specifications

General

Resolution	2560 x 1440 (QHD)
Aspect Ratio	16:9
VESA Mount	100 x 100 mm
Connectivity	HDMI 2.0
Viewing Angle	178°
AMD FreeSync	AMD FreeSync Premium Pro