HP P6000 Installation Guide

show feature_keys
show initiators [ fc | iscsi ]
show iscsi [ <PORT_NUM> ]
show isns
show logs [ <ENTRIES> ]
show luninfo
show luns
show memory
show mgmt
show ntp
show perf [ byte | init_rbyte | init_wbyte | tgt_rbyte | tgt_wbyte ]
show presented_initiators [ fc | iscsi ]
show presented_targets [ fc | iscsi ]
show properties
show rpcinfo
show snmp
show stats
show system
show targets [ fc | iscsi ]
show vpgroups [vpgroup index]
shutdown
target [ add | rm ]
targetmap [ add | rm ]
traceroute
iSCSI Server Connectivity Command Set:
========================================
lunmask [ add | rm ]
show [initiators_lunmask | lunmask ]
show initiators_lunmask
show lunmask
Once you have established initial connectivity with the iSCSI or iSCSI/FCoE module management
ports, HP recommends that you verify the iSCSI or iSCSI/FCoE modules are in a defined state
(before using HP P6000 Command View and beginning a new configuration). To do this, use the
iSCSI and iSCSI/FCoE CLI to reset default factory settings or mappings. This will clear IP addresses
that were set and requires a reboot. The following is an example of resetting factory settings and
mappings on the iSCSI module:
CLI example of: login
reset [ factory | mappings ]
reboot
MEZ50 login: guest
Password: password
Welcome to MEZ50
******************************************************
* *
* HP StorageWorks MEZ50 *
* *
******************************************************
MEZ50 #> admin start –p config
MEZ50 #> reset factory
Are you sure you want to restore to factory default settings (y/n): y
Please reboot the System for the settings to take affect.
MEZ50 #> reboot
Are you sure you want to reboot the System (y/n): y
System will now be rebooted...
Note: The CLI reset factory operation returns the management port IP address to the DHCP mode and
clears all other persistent settings.
Or
MEZ50 (admin) #> reset mappings
Are you sure you want to reset the mappings in the system (y/n): y
Please reboot the System for the settings to take affect.
MEZ50 (admin) #> reboot
Are you sure you want to reboot the System (y/n): y
System will now be rebooted...
Note: The CLI reset mappings operation only clears user defined LUN mappings, and does not alter
other persistent data such as IP addresses.
Fibre Channel zoning
The iSCSI and iSCSI/FCoE modules are directly attached to the array controllers through Fibre
Channel ports (Figure 22 (page 38) and Figure 23 (page 38)), therefore, there are no Fibre Channel
zoning requirements for iSCSI connectivity to the P6300/P6500 EVA. HP P6000 Command View
instantiates host objects which contain Fibre Channel ports, with consideration of multipath LUN
Fibre Channel zoning 37

HP P6000 Specifications

General

RAID Levels Supported	0, 1, 5, 6, 10
Form Factor	Rack-mountable
Hard Drive Form Factor	2.5", 3.5"
Drive Types Supported	SAS, SSD, SATA
Redundancy	Redundant power supplies
Host Connectivity	Fibre Channel, iSCSI
Operating Temperature	10° to 35°C (50° to 95°F)