HP P6000 Installation Guide

NOTE: HP recommends using NTP settings if available on your IP network. This can provide
redundancy with multiple time servers.
Figure 37 Set iSCSI Controller Time
Upgrading the iSCSI or iSCSI/FCoE module firmware
NOTE: HP recommends that you always use the current versions of iSCSI and iSCSI/FCoE module
firmware, which is available on HP Software Depot:
http://www.hp.com/software.hp.com
Updating the iSCSI or iSCSI/FCoE module firmware is separate from upgrading the XCS controller
software, but the process is the same (using the Code Load function in HP P6000 Command View).
NOTE: HP recommends that you update one module at a time to avoid a service interruption.
To update the module firmware:
1. Select the iSCSI controller in the Navigation pane.
2. Select Code Load.
The Code Load iSCSI Controller window opens (Figure 38 (page 44)).
Figure 38 Code Load iSCSI Controller
3. Select Browse, and navigate to the new image file.
4. Select Next Step.
5. Select Finish.
6. Enter YES in the open dialog box.
7. Select Update.
The iSCSI or iSCSI/FCoE module will reboot after it is upgraded.
44 Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View

HP P6000 Specifications

General

RAID Levels Supported	0, 1, 5, 6, 10
Form Factor	Rack-mountable
Hard Drive Form Factor	2.5", 3.5"
Drive Types Supported	SAS, SSD, SATA
Redundancy	Redundant power supplies
Host Connectivity	Fibre Channel, iSCSI
Operating Temperature	10° to 35°C (50° to 95°F)