HP P6000 Installation Guide

Figure 42 Locate button in iSCSI Controller Properties
3. Select Locate ON on the Locate Hardware Device window (Figure 43 (page 47)).
Figure 43 Locate hardware device
NOTE: The flashing blue Locate LED turns off after 15 minutes.
Locating the iSCSI or iSCSI/FCoE modules 47

HP P6000 Specifications

General

RAID Levels Supported	0, 1, 5, 6, 10
Form Factor	Rack-mountable
Hard Drive Form Factor	2.5", 3.5"
Drive Types Supported	SAS, SSD, SATA
Redundancy	Redundant power supplies
Host Connectivity	Fibre Channel, iSCSI
Operating Temperature	10° to 35°C (50° to 95°F)