Reverse this procedure to install the power connector cable.
Speakers
Description Spare part number
Speakers 767262-001
Before removing the speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 29), and then remove the following components:
a. Service door (see
Service door on page 30)
b. Optical drive (see
Optical drive on page 32)
c. Top cover (see
Top cover on page 39)
d. System board (see
System board on page 49)
Remove the speakers:
▲
Lift the speaker cable (1) and then remove the speakers (2)
NOTE: The speaker connection cable was removed when removing the system board.
Reverse this procedure to install the speakers.
58 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
Need help?
General
