CAUTION: To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module, and do not bend the memory module.
a. Aligning the notched edge (1) of the memory module with the tab in the memory module slot.
b. With the memory module at a 45-degree angle from the surface of the memory module
compartment, pressing the module (2) into the memory module slot until it is seated.
c. Gently pressing the memory module (3) down, applying pressure to both the left and right
edges of the memory module, until the retention clips snap into place.
11. Align the tabs (1) on the memory module compartment cover with the notches on the computer.
12. Close the cover (2).
13. Insert and tighten the four memory module compartment screws (3).
14. Replace the battery.
15. Turn over the computer.
80 Chapter 10 Memory modules
To Next Page
Loading...
Need help?
General