2–26 Hardware and Software Guide
Power
■ The system will not decrease hard drive speed while the
notebook is idle.
■ System-initiated standby will not occur.
To fully discharge the battery pack:
1. Disable hibernation. To disable hibernation:
a. Select Start > Control Panel > Performance and
Maintenance > Power Options > Hibernate tab.
b. Clear the Enable hibernation check box
.
2. Select Start > Control Panel > Performance and
Maintenance > Power Options > Power Schemes tab.
a. Record the power scheme displayed in the Power
schemes field so you can reapply it after the calibration.
b. Use the Power schemes drop-down list to select the
Always On power scheme.
c. Record all settings in the Running on batteries column,
so you can reset them after the calibration.
d. Use the drop-down lists in the Running on batteries
column to set each item in the column to Never.
e. Select OK.
3. Disconnect the notebook from the external power source,
but do not turn off the notebook.
4. Run the notebook on battery power until the battery pack is
fully discharged. When the battery pack is fully discharged,
the notebook is shut down.
To Next Page
Loading...
Need help?
General