Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-3 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears
after a power cycle or reboot. If the user does not enter the correct power-on password, the unit
will not boot.
Device Security Allows you to set Device Available/Device Hidden for:
●
System Audio
●
Network Controller (some models)
● SATA0
●
SATA1
USB Security Allows you to enable or disable groups of USB ports or individual USB ports. Default is device
available.
● Front USB Ports
◦
USB Port 9
◦
USB Port 10
● Rear USB Ports
◦ USB Port 2
◦
USB Port 3
◦
USB Port 4
◦ USB Port 5
●
internal USB Ports
◦
USB Port 0
◦ USB Port 11
Slot Security Allows you to disable or enable the Mini Card slot. Default is enable.
Network Boot Enables/disables the computer’s ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI
Express expansion card or embedded on the system board.) Default is enable.
Computer Setup (F10) Utilities 13
To Next Page
Loading...
