Heat Sink Cover
The heat sink cover protects the heat sink and system board. It is secured with five Torx screws.
Figure 6-28 Heat sink cover location
To remove the heat sink cover:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 26).
2. Remove the center access panel (see
Hinge Cover Panel on page 27).
3. Remove the memory access panel (see
Memory Access Panel on page 29).
4. Remove the five black Torx screws that secure the cover to the computer.
Figure 6-29 Heat sink cover screws
Heat Sink Cover 45
To Next Page
Loading...
