EasyManua.ls Logo

HP Pro 4300 - WLAN Module

HP Pro 4300
133 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WLAN Module
The WLAN module is located on the bottom left of the system board. The module is secured with one
Phillips screw and has two connected antennas.
Figure 6-54 WLAN module location
To remove the WLAN module:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 26).
2. Remove the center access panel (see
Hinge Cover Panel on page 27).
3. Remove the memory access panel (see
Memory Access Panel on page 29).
4. Remove the drive access panel (see
Drive Access Panel on page 31).
5. Remove the stand (see
Stand on page 54).
6. Remove the optical drive (see
Optical Drive on page 33).
7. Remove the top panel (see
Top Panel on page 51).
8. Remove the rear cover (see
Rear Cover on page 55).
9. Remove the heat sink cover (see
Heat Sink Cover on page 45).
10. Remove the system board shield (see
System Board Shield on page 62).
64 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis

Table of Contents

Related product manuals