Display Cable
The main display cable connector is located behind the system board. You must remove the system
board to remove the display cable.
Figure 6-66 Display cable location
To remove the display cable:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 26).
2. Remove the center access panel (see
Hinge Cover Panel on page 27).
3. Remove the memory access panel (see
Memory Access Panel on page 29).
4. Remove the drive access panel (see
Drive Access Panel on page 31).
5. Remove the stand (see
Stand on page 54).
6. Remove the optical drive (see
Optical Drive on page 33).
7. Remove the heat sink cover (see
Heat Sink Cover on page 45).
8. Remove the heat sink (see
Heat Sink (Thermal Module) on page 47.
9. Remove the top panel (see
Top Panel on page 51).
10. Remove the rear cover (see
Rear Cover on page 55).
11. Remove the system board shield (see
System Board Shield on page 62).
12. Remove the system board (see
System Board on page 70).
Display Cable 75
To Next Page
Loading...
