12. If it is necessary to replace the WLAN antennas, remove the cables from the clips in the bottom of the
enclosure (1), and then peel the antennas and remove them from the display enclosure (2).
WLAN antennas are available as spare part number L78053-001.
13. If it is necessary to remove or replace the display/camera cable, use the following steps:
Displays with an HD camera and WWAN
a. Rotate the WWAN antennas (1), and then disconnect the WWAN cable (2).
b. Disconnect the cable from the ZIF connector on the camera module (3).
66 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
