12. Separate the display assembly (3) from the computer.
13. To remove the display bezel and access the display assembly internal components:
To avoid damaging the display panel, do not use a tool to release the inside edges of the display
bezel. You can use a tool only when you insert it from the outside edges of the top, left, and right
edges of the bezel. Use your fingers to lift up on the bezel. Avoid pressing down on the panel during
bezel removal.
a. Use a thin plastic tool (1), such as a case utility tool, to separate the outside edges of the
display bezel from the display assembly.
b. In the following sequence, release the top (2), left (3) and right, and bottom (4) edges of the
display bezel from the display assembly.
c. Remove the display bezel (5).
The display bezel is available using the following spare part numbers:
● N96947-001: For use on computer models equipped with an infrared webcam
● N96946-001: For use on compuer models equipped with an FHD webcam
● N96948-001: For use on computer models not equipped with a webcam
60
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
