Select To do this
●
Enable/disable SD Card boot (enabled by default).
●
Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (enabled by
default).
●
Enable/disable Unified Extensible Firmware Interface
(UEFI) Boot Mode (disabled by default).
●
Set the Legacy Boot Order.
Device Configurations
●
Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
◦
Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not running
◦
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer
●
Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced Parallel
Port).
●
Enable/disable fan always on while connected to an AC
outlet (disabled by default).
●
Enable/disable Data Execution Prevention (select models
only). When enabled, the processor can disable some
virus code execution, which helps to improve computer
security (disabled by default).
●
SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦
AHCI (Advanced Host Controller Interface)
◦
IDE (Integrated Drive Electronics)
◦
RAID (select models only)
NOTE: Availability of these options varies by computer
model.
●
Enable/disable secondary battery fast charge (enabled by
default).
●
Enable/disable HP QuickLook (enabled by default).
●
Enable/disable Preboot Authentication on HP QuickLook
Boot (enabled by default).
●
Enable/disable HP QuickWeb (enabled by default).
●
Enable/disable HP QuickWeb Elevated Security
(disabled by default).
●
Enable/disable Virtualization Technology (select models
only; disabled by default).
●
Enable/disable Wake on USB (enabled by default).
144 Chapter 13 Computer Setup
To Next Page
Loading...
Need help?
General
