Select To do this
●
Enable/disable Num lock state at boot (disabled by
default).
●
Enable/disable TXT (Intel® Trusted Execution
Technology) (select models only; disabled by default).
Built-In Device Options
●
Enable/disable the wireless button state (enabled by
default).
●
Enable/disable embedded WLAN device radio (select
models only; enabled by default).
●
Enable/disable the Network Interface Controller (LAN)
(enabled by default).
●
Enable/disable the embedded Bluetooth® device radio
(enabled by default).
●
Enable/disable LAN/WLAN switching (disabled by
default).
●
Enable/disable LAN Power Save (select models only).
When enabled, saves power by turning off the LAN when
not in use (enabled by default).
●
Set the wake on LAN state. Options include the
following:
◦
Disabled
◦
Boot to Network
◦
Follow Boot Order
●
Enable/disable the Notebook Upgrade Bay device
(enabled by default).
●
Enable/disable the Power Monitor Circuit (enabled by
default).
●
Enable/disable the audio devices (enabled by default).
●
Enable/disable the fingerprint device (enabled by
default).
●
Enable/disable a modem device (enabled by default).
●
Enable/disable the microphone (enabled by default).
●
Enable/disable the internal speakers (enabled by
default).
Port Options (all are enabled by default) NOTE: All port options are enabled by default.
●
Enable/disable the serial port.
●
Enable/disable the parallel port.
●
Enable/disable the flash media reader.
●
Enable/disable the USB port.
CAUTION: Disabling the USB port also disables
MultiBay devices and ExpressCard devices on the
advanced port replicator.
Computer Setup menus 145
To Next Page
Loading...
Need help?
General
