Serial connector and cable
Description Spare part number
Serial connector and cable for use only with computers equipped with a 15.6-in display assembly 613313-001
Before removing the serial connector and cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 72).
5.
Remove the following components:
a.
Bluetooth module (see
Bluetooth module on page 74)
b.
Mass storage device (see
Mass storage device on page 75)
c.
Optical drive (see
Optical drive on page 86)
d.
Keyboard (see
Keyboard on page 88)
e.
Switch cover (see
Switch cover on page 94)
f.
Fan (see
Fan on page 102)
g.
Heat sink (see
Heat sink on page 104)
h.
Palm rest (see
Palm rest on page 98)
i.
TouchPad (see
TouchPad on page 100)
j.
Display assembly (see
Display assembly on page 109)
k.
Top cover (see
Top cover on page 121)
l.
ExpressCard assembly (see
ExpressCard assembly on page 126)
m.
Speaker assembly (see
Speakers on page 130)
Remove the serial connector and cable:
1. Disconnect the serial connector cable (1) from the system board.
2. Remove the two Hex HM5.0×10.0 screw locks (2) that secure the serial connector to the base
enclosure.
140 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
