Before removing the mass storage device, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 72).
Remove the mass storage device:
1.
Position the computer with the front toward you.
2. Loosen the two Phillips PM2.0×6.0 captive screws (1) that secure the mass storage device cover
to the computer.
3. Lift the left side of the cover (2) to detach it from the computer.
4. Remove the mass storage device cover (3). The mass storage device cover is included in the
Plastics Kit, spare part numbers 613343-001 (for use only with computer models equipped with a
15.6-in display assembly) and 613344-001 (for use only with computer models equipped with a
14.0-in display assembly).
5. Loosen the Phillips PM2.5×13.0 captive screw (1) that secures the mass storage device in the
mass storage device bay.
6. Grasp the Mylar tab (2) on the mass storage device bracket, and slide the mass storage device
(3) to the right to disconnect it from the system board.
76 Chapter 4 Removal and replacement procedures
To Next Page
