HP ProCurve 2510G Series User Manual

6-8
Configuring Secure Shell (SSH)
General Operating Rules and Notes
General Operating Rules and Notes
■ Public keys generated on an SSH client must be exportable to the
switch. The switch can only store ten client key pairs.
■ The switch’s own public/private key pair and the (optional) client
public key file are stored in the switch’s flash memory and are not
affected by reboots or the erase startup-config command.
■ Once you generate a key pair on the switch you should avoid re-
generating the key pair without a compelling reason. Otherwise, you
will have to re-introduce the switch’s public key on all management
stations (clients) you previously set up for SSH access to the switch.
In some situations this can temporarily allow security breaches.
■ On ProCurve switches that support stacking, when stacking is
enabled, SSH provides security only between an SSH client and the
stack manager. Communications between the stack commander and
stack members are not secure.
■ The switch does not support outbound SSH sessions. Thus, if you
Telnet from an SSH-secure switch to another SSH-secure switch, the
session is not secure.

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)