HP ProCurve 2510G Series User Manual

3-23
Web and MAC Authentication
Configuring MAC Authentication on the Switch
Configure the Switch for MAC-Based Authentication
Command Page
Configuration Level
aaa port-access mac-based addr-format 3-23
[no] aaa port-access mac-based [e] < port-list >3-23
[addr-limit] 3-24
[addr-moves] 3-24
[auth-vid] 3-24
[logoff-period] 3-24
[max-requests] 3-24
[quiet-period] 3-25
[reauth-period] 3-25
[reauthenticate] 3-25
[server-timeout] 3-25
[unauth-vid] 3-25
Syntax: aaa port-access mac-based addr-format
<no-delimiter|single-dash|multi-dash|multi-colon>
Specifies the MAC address format to be used in the
RADIUS request message. This format must match the
format used to store the MAC addresses in the RADIUS
server. (Default: no-delimiter)
no-delimiter — specifies an aabbccddeeff format.
single-dash — specifies an aabbcc-ddeeff format.
multi-dash — specifies an aa-bb-cc-dd-ee-ff format.
multi-colon — specifies an aa:bb:cc:dd:ee:ff format.
Syntax: [no] aaa port-access mac-based [e] < port-list >
Enables MAC-based authentication on the specified
ports. Use the no form of the command to disable MAC-
based authentication on the specified ports.

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)