9-34
Configuring and Monitoring Port Security
Reading Intrusion Alerts and Resetting Alert Flags
will see that the Intrusion Alert entry for port A1 has changed to “No”.
(Executing show port-security intrusion-log again will result in the same display
as above, and does not include the Intrusion Alert status.)
ProCurve(config)# port-security a1 clear-intrusion-flag
ProCurve(config)# show interfaces brief
Figure 9-18. Example of Port Status Screen After Alert Flags Reset
For more on clearing intrusions, see “Note on Send-Disable Operation” on
page 9-30.
Using the Event Log To Find Intrusion Alerts
The Event Log lists port security intrusions as:
W MM/DD/YY HH:MM:SS FFI: port A3 - Security Violation
where “
W” is the severity level of the log entry and FFI is the system module
that generated the entry. For further information, display the Intrusion Log,
as shown below.
From the CLI. Type the log command from the Manager or Configuration
level.
Syntax: log [search-text ]
For search-text , you can use ffi, security, or violation. For example:
To Next Page
Loading...
Need help?
General
