HP ProCurve 2510G Series User Manual

8-25
Configuring Port-Based and Client-Based Access Control (802.1X)
Configuring Switch Ports as 802.1X Authenticators
6. Optionally Resetting Authenticator Operation
After authentication has begun operating, these commands can be used to
reset authentication and related statistics on specific ports.
Syntax: aaa port-access authenticator < port-list >
[initialize]
On the specified ports, blocks inbound and outbound
traffic and restarts the 802.1X authentication process.
This happens only on ports configured with control auto
and actively operating as 802.1X authenticators.
[reauthenticate]
On the specified ports, forces reauthentication (unless
the authenticator is in “HELD” state).
[clear-statistics]
On the specified ports, clears authenticator statistics
counters.

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)