HP ProCurve 2510G Series User Manual

7-12
Configuring Secure Socket Layer (SSL)
General Operating Rules and Notes
Note “Zeroizing” the switch’s server host certificate or key automatically disables
SSL (sets web-management ssl to No). Thus, if you zeroize the server host
certificate or key and then generate a new key and server certificate, you must
also re-enable SSL with the web-management ssl command before the switch
can resume SSL operation.
CLI Command to view host certificates.
To view the current host certificate from the CLI you use the show crypto
host-cert command.
For example, to display the new server host certificate:
Figure 7-4. Example of show crypto host-cert command
Syntax: show crypto host-cert
Displays switch’s host certificate
Show host certificate command

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)