8-48
Configuring Port-Based and Client-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
show port-access authenticator (Syntax Continued)
config [[e] < port-list >]
Shows:
• Whether port-access authenticator is active
• The 802.1X configuration of the ports configured as
802.1X authenticators
•Use show running to view the current client-limit
configuration available for switches.
If you do not specify < port-list >, the command lists all
ports configured as 802.1X port-access authenticators.
Does not display data for a specified port that is not
enabled as an authenticator.
statistics [[e] < port-list >]
Shows:
• Whether port-access authenticator is active
• The statistics of the ports configured as 802.1X
authenticators, including the supplicant’s MAC
address, as determined by the content of the last
EAPOL frame received on the port.
Does not display data for a specified port that is not
enabled as an authenticator.
session-counters [[e] < port-list >]
Shows:
• Whether port-access authenticator is active
• The session status on the specified ports configured
as 802.1X authenticators
Also, for each port, the “User” column lists the user
name the supplicant included in its response packet.
(For the switch, this is the identity setting included in
the supplicant command—page 8-45.) Does not display
data for a specified port that is not enabled as an
authenticator.
vlan [< port-list >]
Shows per-port:
■ The Access Control setting
■ Unauth-VLAN ID (if any)
■ Auth-VLAN ID (if any)
To Next Page
Loading...
Need help?
General
