HP ProCurve 2510G Series User Manual

4 – Index
LACP not allowed … 8-58
local … 8-23
local username and password … 8-4
messages … 8-58
open VLAN
authorized client … 8-28
configuration … 8-35, 8-37
general operation … 8-26
mode … 8-26
operating notes … 8-38
operating rules … 8-31
PVID, no … 8-50
security breach … 8-38
set up … 8-34
status, viewing … 8-50
suspended VLAN … 8-51
unauthorized client … 8-28
use models … 8-28
VLAN, after authentication … 8-28, 8-32,
8-39
VLAN, tagged … 8-26, 8-28, 8-29, 8-32, 8-39,
8-52
operation … 8-10
port-security, with 802.1X … 8-40
RADIUS host IP address … 8-24
rules of operation … 8-12
See 802.1x access control.
show commands … 8-47
show commands, supplicant … 8-53
statistics … 8-47
supplicant operation … 8-12
supplicant operation, switch-port … 8-11
supplicant state … 8-53
supplicant statistics, note … 8-53
supplicant, configuring … 8-42
supplicant, configuring switch port … 8-44
supplicant, enabling … 8-44
switch username and password … 8-4
troubleshooting, gvrp … 8-54
used with port-security … 8-40
VLAN operation … 8-54
ports, protected … 9-37
prior to … 9-32, 9-33, 9-36
Privacy Enhanced Mode (PEM)
See SSH.
privilege-mode … 4-12, 4-15
protected ports … 9-37
configuring … 9-37
logical ports … 9-37
show
protected ports
show running config …9-38
proxy
web server … 9-36
Q
quick start … 1-8
R
RADIUS
accounting … 5-2, 5-25
accounting, configuration outline … 5-27
accounting, configure server access … 5-28
accounting, configure types on switch … 5-30
accounting, exec … 5-26, 5-30
accounting, interim updating … 5-32
accounting, network … 5-30
accounting, operating rules … 5-27
accounting, server failure … 5-27
accounting, session-blocking … 5-32
accounting, start-stop method … 5-31
accounting, statistics terms … 5-34
accounting, stop-only method … 5-31
accounting, system … 5-26, 5-30
authentication options … 5-2
authentication, local … 5-16
authorization … 5-17
authorized IP managers, precedence … 10-2
bypass RADIUS server … 5-9
commands authorization … 5-17
commands, accounting … 5-25
commands, switch … 5-6
configuration outline … 5-7
configure server access … 5-10
configuring commands authorization … 5-19
configuring switch global parameters … 5-12
general setup … 5-5
HP-Command-Exception … 5-19
HP-command-string … 5-19
local authentication … 5-9
MD5 … 5-4
messages … 5-40
network accounting … 5-26
operating rules, switch … 5-4

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)