HP ProCurve 2510G Series User Manual

4-12
TACACS+ Authentication
Configuring TACACS+ on the Switch
Command Syntax
Syntax: aaa authentication
< console | telnet | ssh | web | web-based | port-access >
Selects the access method for configuration.
< enable>
The server grants privileges at the Manager privilege
level.
<login [privilege-mode] >
The server grants privileges at the Operator privilege
level. If the privilege-mode option is entered, TACACS+ is
enabled for a single login. The authorized privilege level
(Operator or Manager) is returned to the switch by the
TACACS+ server.
Default: Single login disabled.
< local | tacacs | radius >
Selects the type of security access:
local — Authenticates with the Manager and Operator
password you configure in the switch.
tacacs — Authenticates with a password and other
data configured on a TACACS+ server.
radius — Authenticates with a password and other
data configured on a RADIUS server.
[< local | none >]
If the primary authentication method fails, determines
whether to use the local password as a secondary method
or to disallow access.
aaa authentication num-attempts < 1-10 >
Specifies the maximum number of login attempts allowed in
the current session. Default: 3

HP ProCurve 2510G Series Specifications

General

Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Manageable	Yes
Storage Temperature	-40°C to 70°C
Ports	24 x 10/100/1000 ports
Memory	128 MB
Jumbo Frame Support	Yes
Layer	Layer 2
Features	VLAN, QoS, ACLs, IGMP snooping
Management	Web interface, CLI, SNMP
Security Features	RADIUS, TACACS+
Power Supply	Internal power supply
Operating Temperature	0°C to 45°C
Power over Ethernet (PoE)	Optional (PoE models available)