HP ProCurve 2610 - Getting Started

1-11
Introducing the Switch
Back of the Switch
Introducing the Switch
Console Port
This port is used to connect a console to a 2610 Switches by using the
RJ-45 to DB9 cable, supplied with the switch. This connection is described
under “8. (Optional) Connect a Console to the Switch” on page 26 in chapter
2, “Installing the Switch.” The console can be a PC or workstation running a
VT-100 terminal emulator, or a VT-100 terminal.
Back of the Switch
Figure 1-3. ProCurve Switch 2610-24 and 2610-48 non-PWR
Figure 1-4. ProCurve Switch 2610-24-PWR and 2610-48-PWR
Figure 1-5. ProCurve Switch 2610-24/12PWR
AC power connector
RPS Input
AC power connector
RPS Input
EPS Input
EPS Input
AC power
connector
RPS Input