EasyManuals Logo

HP ProCurve 2824 User Manual

HP ProCurve 2824
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
2-8
Installing the Switch
Installation Procedures
Installing the Switch
Removing the mini-GBICs:
Note You should disconnect the network cable from the mini-GBIC before removing
it from the switch.
Depending on when you purchased your HP ProCurve mini-GBIC, it may have
either of three different release mechanisms: a plastic tab on the bottom of
the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail.
To remove the mini-GBICs that have the plastic tab or plastic collar, push the
tab or collar toward the switch until you see the mini-GBIC release from the
switch (you can see it move outward slightly), and then pull it from the slot.
To remove the mini-GBICs that have the wire bail, lower the bail until it is
approximately horizontal, and then using the bail, pull the mini-GBIC from the
slot.

Table of Contents

Other manuals for HP ProCurve 2824

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2824 and is the answer not in the manual?

HP ProCurve 2824 Specifications

General IconGeneral
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
VLAN SupportYes
LayerLayer 2
Rack MountableYes
Jumbo Frame SupportYes
ManagementCLI, SNMP
FeaturesLink Aggregation, QoS
Dimensions1.7 inches
Ports24 x 10/100/1000

Related product manuals